View full version: IDI Engine
  1. 1.6IDI Not Fully Rotating/Not Starting
  2. Awakened from a long slumber....
  3. Booster full of brake fluid
  4. Sharing my 1.6td project
  5. Aaz injection line differences
  6. Greater than 20psi mods AAZ T3
  7. Help w cam ID
  8. Cylinder head passage
  9. AAZ rebuild (broke down in Maine)
  10. Turbo 1.6NA checklist
  11. Just wondering about this transmission troubles
  12. 1.9 AAZ
  13. HE200WG: Which turbine housing?
  14. Aaz head salvageable?
  15. Turbo pump and VNT question
  16. Crankshaft Pulley fell off
  17. Source for new oversize pistons
  18. Torque specs
  19. K14 Turbo Rebuild
  20. Am I operating on a misunderstanding?
  21. Water pump replacement pitted surface
  22. Looking for pics and/or part number of 1V Ecodiesel drain line.
  23. AAZ K14 turbo on 1.6td
  24. Turbo converted polo 1.4d(n/a) (1W) with video´s
  25. What injectors to use on a 1.9TD AAZ?
  26. Anyone with an AAZ Head Gasket Chart handy?
  27. Injectors installed without heatshields.
  28. Arco AAZ Pistons Does the Coating change the piston to bore spec?
  29. AAZ Vanagon boost peaks holds for a second then drops off after adjusting fuel
  30. Oil pan mating surface corrosion on block
  31. 4 diesel mk1's at the junkyard
  32. Injection pump damaged by forcing cold start cable at TDC?
  33. 1.6TD Glow plug activation
  34. What is a symptom of the piston striking the head?
  35. Head of Toast?
  36. NOS CY condition
  37. How to make a AAZ K03 Hybrid Turbo?
  38. 1.6TD bore scratches
  39. AMC 1.6TD head after 5000miles
  40. AAZ rod wear @tangs
  41. New Bosch VE pump - basic settings
  42. crossposting - MK2 overheat / water pump questions
  43. Disassembling veggie block w/ piston slap- rod length?
  44. NOS 1.6td pumpe!
  45. K03 Bad Wastegate Actuator?
  46. 5 turbo side-by-side
  47. 1.6TD manual boost controller
  48. Oil in exhaust
  49. 1.6 timing belt break results
  50. Question on compression testing